Toyota G and Toyota H Chip Vehicle OBD Remote Key Programming Device

Toyota G, Toyota Motor OBD remote key chip programming equipment supports the programming of Toyota G, Toyota chip vehicles through the OBD2 port.
Toyota G, Toyota Motor OBD remote programming key device chip
Toyota G, Toyota chip car OBD Remote key programmer Description:
Suitable for 4d67,68,72 (G), chips that support G and H, tested in 2015 Camry
Toyota adds remote control Get in the car, close the door, insert the key, turn the key, insert the device into the OBD.
In sound (deep), it will start adding remote control. In the sound (di-di-), open the door when hearing a shrill voice. Press the Lock & amp; unlock key at the same time. and press the "lock" key.
If the treble end, it's all right.
Note: The switch is on the right (add remote control).
Toyota Add Transponder: Get in the car, close the door, insert the main key into the lock, turn the key, and then insert the device into the OBD.
If it will sound two times, it will begin to increase the transponder. In the sound (Didi-), 2-3 minutes later, the burglar lamp is lit.
Then remove the key (anti-theft lamp flash), insert the new key, do not need to turn the key,

The anti-theft light will be turned off.

Toyota G and Toyota H Chip Vehicle OBD Remote Key Programmer Description:

Apply to 4D67,68,72(G), support both G and H chip, test on 2015 Camry

Toyota Add Remote Control

Get in the car and close the door, insert the key and turn the key on, insert the device into OBD. After the sound(Dee-), it will start to add the remote control.
After the sound ( Dee- Dee-),open the door, when hear the sound blaring. Press ‘ lock & unlock’ key at the same time. And press the’ lock’ key. If the blaring end, It’s OK.
Note: Switch is on the right (add remote control).

Toyota Add Transponder:

Get in the car and close the door, insert the main key into the lock and turn the key on,and then insert the device into the OBD. If it will sound twice, it will start to add transponder.
After the sound (Dee-Dee-), 2-3 minutes later, anti-theft light is on. And then remove the key( anti-theft light will flash), insert the new key and doesn’t need turn the key,
anti-theft light will be off later.
Note: switch is on the left.( add transponder)

Customer Feedback:

Package including:

1pc x Toyota G and H OBD Remote Key Programmer